Weld line assessment - 2 vertical welds.xls

Properties of Fillet Weld Groups - Welds treated as lines

The method of assessing fillet welds groups treating welds as lines is reasonably safe and conservative and is very convenient to use.

a) Weld subject to bending....See table below for typical unit areas and unit Moments of Inertia.A fillet weld subject to bending is easily assessed as follows.

1) The area of the fillet weld A_u..(unit thickness) is calculated assuming the weld is one unit thick..
2) The (unit) Moment of Inertia I_u is calculated assuming the weld is one unit thick..
3) The maximum shear stress due to bending is determined... 4) The maximum shear stress due to direct shear is determined.. 5) The resultant stress 6) By comparing the design stress S_s with the resultant stress i.e. if the
a) Weld subject to torsion...See table below for typical unit areas and unit Polar moments of Inertia. A fillet weld subject to torsion is easily assessed as follows.

1) The area of the fillet weld A_u (unit thickness) is calculated assuming the weld is one unit thick
2) The (unit) Polar Moment of Inertia J_u is calculated assuming the weld is one unit thick.. The polar moment of inertia J = I_xx + I_yy
3) The maximum shear stress due to torsion is determined... 4) The maximum shear stress due to direct shear is determined.. 5) The resultant stress 6) By comparing the design stress S_s with the resultant stress i.e. if the

Calculation Reference
Schaum's Outline - Machine Design