This sheet , check bolt under shear and tension forces according to CAN/CSA S16-01 and AMAA-TIR-A9-14.Moreover, check bearing cap...

Given the clamping thickness, the bolt length would be calculated

                                     The minimum and maximum fastener spacing, end distances, and edge distances for steel plates are t...

Calculates the allowable pre-load after a user input shear load or the allowable shear load after a user input pre-load for coa...

The Bolt Torque/Tension calculation provides a simple estimation of the tension in a bolt based on the torque imposed or vice versa. The ...

To determine the force distribution in a preloaded bolted joint, you can follow these steps:

Understand the Joint Configuration...

When bolts are subjected to combined shear and tension loads, their overall strength is determined by considering the inter...

BS 449: Part 2 is a British standard that provides guidelines for the structural use of steel. It includes specifications for the capacities of...

I have calculated the Connecting rod bolt analysis with VDI 2230 standards.I still think I have made so many mistakes.Ple...

The design of anchor plates, as per the AISC LRFD (American Institute of Steel Construction Load and Resistance Factor Design) standard, in...

Enter bolt locations, applied load and location of load. Calculates bolt shear, tension, etc. I use this all the time at work and it ma...

Key details about the DIN EN 1515 standard and related flange specifications:

DIN EN 1515 specifies the dimensions of hexagon ...

KNOWN: A double thread Acme screw and a thrust collar, each with known diameter and running friction coefficient, are used to raise a speci...

Purpose of calculation: For an applied load on a screw thread calculate the axial thrust of a nut. Calculate bolt pretension from screw parameter...

This calculation, based on the ASME B1.1 Appendix B standard, is designed to determine the preload force and tightening torque for bolts. By utiliz...

https://www.youtube.com/watch?v=x5G5xPAt5To

The following values are required as inputs to the calculation:

1. BOLT GRADE - Enter the two num...

AMERICAN INSTITUTE OF STEEL CONSTRUCTION, INC. (AISC)
Specification for Structural Steel Buildings Allowable Stress Design and Plastic Design

...

The instantaneous centre of rotation method to determine the ultimate shear capacity of a bolt group, as described in the LRFD Code: The b...